Separating the refill: The two-part label can be easily split into two, individually sealed stacks.
Removing wafers from the refill: Remove the protective film and lift the top wafer, including the top shell, off the stack. Use the finger tabs on either end of the water will lift too.
Refill the rack: It’s so easy! Simply place the wafer, top shell and spacer into an empty rack and click securely in place. The top shell can either remain inside the rack for extra protection or transferred back to the top layer of the open refill if not racking all five at the same time.
Close the lid, refilling is complete: Refilling a rack takes only seconds. The refilled rack can now be used or autoclaved, depending on your application.
Recover the partially used stack: The remaining tips of the refill can be protected from contamination by replacing the top shell. There’s no need to remove the bottom shell when using the last wafer. Both the bottom shell and the wafer fits inside the new rack.
FAQ
Do not use the thumb finger in 10/20 µl XL Tip. when we use a finger in the pipette the flow of solution will be slow. when we did not use the finger on top the flow will be in speed.
When we operate the pipette and 10/20 µl XL Tip. we need to avoid some common mistakes. there are Tip Wiping, Choosing the Wrong Pipetting Mode, Working Too Quickly, and angle of keeping the pipette.
We should not use the dirty pipette and 10/20 µl Tip . because it will not give the accurate result. so we cannot get the fine result.
