Separating the refill: The two-part label can be easily split into two, individually sealed stacks.
Removing wafers from the refill: Remove the protective film and lift the top wafer, including the top shell, off the stack. Use the finger tabs on either end of the water will lift too.
Refill the rack: It’s so easy! Simply place the wafer, top shell and spacer into an empty rack and click securely in place. The top shell can either remain inside the rack for extra protection or transferred back to the top layer of the open refill if not racking all five at the same time.
Close the lid, refilling is complete: Refilling a rack takes only seconds. The refilled rack can now be used or autoclaved, depending on your application.
Recover the partially used stack: The remaining tips of the refill can be protected from contamination by replacing the top shell. There’s no need to remove the bottom shell when using the last wafer. Both the bottom shell and the wafer fits inside the new rack.
FAQ
Pre-wetting the tip before you pipette will help improve your accuracy. also it increases the humidity of the tip. it is the finest one for the 10ul tips.
Pre rinse is the fast one and also increase the accuracy to0.2% for the 10 µl filter tip.
Pre-rinsing the tip for few times helps the balancing of air temperature and capillary effects. in the 10ul tips for pre-rinsing use both hands use horizontal type fill with some mixed solution water rinse the tube. flow the solution. after that you can use it.
The purpose of Pre-rinsing is any case pipetting will not be an accurate value. by pre-rinsing, the 10ul tips will increase the accuracy of the tip also it is easy to fill the solution.
